Suffolk County, NY
Custom Fence & Gate Installation in The Hamptons
Hamptons properties tend to be large, exposed to direct ocean and bay air, and — inside the incorporated villages — subject to design review boards that care as much about sightlines and hedge-adjacent fencing as they do about the fence itself. Ornamental iron and painted wood read as traditional on estate frontage; powder-coated aluminum is the common choice for pool enclosures where salt exposure and low maintenance both matter.
Local Compliance
Built for The Hamptons's
rules, not just its look.
Spans several incorporated villages (East Hampton Village, Southampton Village, Sag Harbor, and others) plus the unincorporated hamlets of East Hampton and Southampton Town — each with its own building department and, in the villages, a design/architectural review board.
General guidance only — exact height, setback, and permit requirements vary by address. We confirm the specifics for your property before finalizing a design.
Village design review
East Hampton Village, Southampton Village, and Sag Harbor each run a design/architectural review process for fencing visible from the street or a public way. Materials, height, and sometimes color can be subject to approval before installation begins.
Pool barrier code
New York State's Uniform Fire Prevention and Building Code sets a statewide floor for pool enclosures: minimum 48" height, with gates that are self-closing, self-latching, open away from the pool, and have the latch release at least 40" above grade. Several Hamptons villages layer stricter height minimums on top of the state floor.
Coastal wind and salt exposure
Direct oceanfront and bayfront lots fall under higher wind-load design categories, and salt-fog corrosion accelerates on untreated steel and standard hardware. We spec marine-grade fasteners and coatings on exposed installations.
Representative Work
Typical project profiles in The Hamptons.
Illustrative examples of the scope and materials we most often build for The Hamptons properties — not specific past addresses.
Estate perimeter — ornamental iron
A representative Hamptons estate profile: painted ornamental iron along the street frontage, sized and detailed to clear village design review, transitioning into a coated chain link back-of-property line for the working side of the lot.
Traditional pickets with custom finials, integrated into an existing hedgerow
Oceanfront pool enclosure — aluminum
Typical scope for an oceanfront pool project: powder-coated aluminum enclosure built to the state 48" minimum and the stricter local height requirement, with marine-grade hardware for salt-air durability.
Flat-top pool-code aluminum with a self-closing, self-latching gate
Materials We Install
Every fence type, built for The Hamptons.
The Hamptons FAQ
Questions we hear
most in The Hamptons.
Does my fence need Design Review Board approval in the Hamptons villages?+−
If your property sits inside an incorporated village — East Hampton, Southampton, or Sag Harbor — and the fence is visible from a street, right-of-way, or neighboring view corridor, it likely needs sign-off before installation. We'll tell you during your estimate whether your address falls inside village lines and help prepare what the board typically wants to see.
What fence material holds up best against ocean salt air?+−
Powder-coated aluminum and vinyl resist salt-fog corrosion with the least upkeep. Ornamental iron can absolutely be done oceanside, but it needs a proper marine-grade coating system and periodic touch-up — we'll walk you through the maintenance tradeoff at your estimate.
Do pool fences need to meet a specific height in the Hamptons?+−
New York State requires at least 48 inches with a self-closing, self-latching gate as a statewide minimum. Some villages require more — we confirm the exact local requirement for your address before we finalize a design.
Can you match a fence to an existing hedge or historic stone wall?+−
Yes — a lot of Hamptons estate work is integrating a new fence or gate into existing hedgerows, stone walls, or historic gate posts rather than replacing the whole boundary. We design around what's already there.